450 SX-F 2025

Specially developed for use in motocross

No O- or Z-rings > minimum loss of power and good durability

Greater flexibility and better running characteristics

Constant and permanent lubrication

Better sealing against water and dirt

Significantly longer durability

Fast preload adjustment

Use of the entire length of the thread on the shock absorber

Very easy operation

Extremely low weight

Dirt-resistance

Mechanical drive

Colour differences between the upper and lower triple clamp cannot be technically ruled out

CNC milled aluminium triple clamp

Elegant anodised surface

Visual highlight

Optimally tuned steering stem stiffness

100% alignment of the fork tubes

Ideal flexibility – precisely customised to the WP fork

Specially optimised geometry of the fork clamping

No ovalization of the fork outer tube

Highly precise and smooth fork response

Maximum handling gain

Gain in stability at the front wheel

Overall, more homogeneous force flows in the entire vehicle

Simple offset adjustment

Including steering stem with steering head bearing already pressed on

Very simple offset adjustment of 20 or 22mm

Shorter offset: Stability on fast straights

Longer offset: easier and quicker cornering in curves

Elegant anodised surface

Visual highlight

CNC milled aluminium triple clamp

Including steering stem with steering head bearing already pressed on

CNC milled from high-strength aluminium

Elegant anodised surface

Visual highlight

CNC milled from high-strength aluminium

Elegant anodised surface

Visual highlight

Wider contact surface than standard:

+8mm at 125/150 SX/XC-W, SX-F, 450/500 EXC-F

+16mm at 250/300 SX/EXC, 250/350 EXC-F

DID YOU KNOW that all KTM CNC parts are manufactured from high grade aluminium, which not only looks great but can also stand up to the toughest loads?

The original factory look, anodized aluminium PowerParts are just the thing to give your KTM that something special

With return valve

Anodised dust protection cap

Quick and easy bleeding of the brake

With return valve

Anodised dust protection cap

Quick and easy bleeding of the brake

Made of high-strength aluminium

Improved braking performance

Only for Brembo brake systems

Required for using the 320 mm brake disc 58309060000 with Brembo brake caliper

Increases the volume of the rear master cylinder

Additional cooling ribs minimise the heating of the brake fluid

Eliminates “fading” almost completely

Total height including cover approximately 26.5mm

Made of high-quality carbon

Protects the rear brake disc from stones and other solid obstacles

Can be fitted on the CNC brake calliper support 77713975044 or 7771397511030 or 7251397500030

High stiffness and strength

CNC milled from high-strength aluminium

Lighter than series components

Improved braking performance

Clear pressure point across the entire temperature range

More brake power

Higher stiffness with the same weight

Made of high-strength aluminium

Clear pressure point across the entire temperature range

More brake power

Higher stiffness with the same weight

Made of high-strength aluminium

Outer ring made of stainless high-performance brake steel

Larger diameter for added braking performance

Floating

Outer ring made of stainless high-performance brake steel

Inner ring anodised

Minimal wear on brake pads

Softer due to high content of organic substances

Thermal insulation by means of ceramic underlayer

Less aggressive brake feel

Lower friction coefficient than sintered brake pads

Special material mixture